 |
|
|
| |
|
|
|
|
|
|
- (1)
- (1)
- (1)
- (1)
- (1)
- (1)
- (1)
- (4)
- (1)
- (1)
- (1)
- (1)
- (1)
- (1)
|
|
| |
|
|
Build Your Online Product Catalogs?
| Product Name: |
LED Light Ribbon
|
| Supply Ability: |
1kk meters |
| Related proudcts |
|
| Specifications |
customed size |
| Price Term: |
FOB |
| Port of loading: |
Shenzhen |
| Minimum Order |
1000 pcs |
| Unit Price: |
T/T |
|
Applications:
Edge lighting of tran***rent or diffused materials
Path and contour marking
Illuminating signs
Basic Technical Data:
Standard length: 5 meters/reel or 8 meters/reel (RGB tri-color B)
Ribbon width: single color (8mm), RGB tri-color A (10mm), RGB tri-color B (12mm)
Printed circuit board thickness: single color (0.25mm), RGB tri-color (0.2mm)
Operating voltage: 12VDC
Operating current: single color (2A), RGB tri-color A (3A), RGB tri-color B (4.8A)
Entire ribbon LED quantity: single color (300pcs), RGB tri-color A (150pcs), RGB tri-color B (240pcs)
Size of smallest unit 3 LED (L*W): single color (40mm?mm), RGB tri-color A (100mm?0mm), RGB tri-color B (100mm?2mm)
Assembly Information:
1.Solder connection should only be performed on designated solder pads (marked with “±?. During soldering, don’t exceed the maximum soldering time of 10 seconds and the maximum soldering temperature of 260 Celsius degrees.
2.The smallest unit (50mm or 100mm, 3 LEDs) can be removed by cutting with scissors between the designated solder pads.
3.The mounting of the ribbon is facilitated means of double side adhensive on the back surface of the ribbon. Care must be take to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirty partied. The mounting substrate must have sufficient structural integrity. Take care to completely remove the adhensive backing. Once the ribbon is appropriately positioned. Press on the ribbon with about 20N/m2 (refer to application techniques of 3M adhensive tapes)
4.The minimum bending radius is 2cm. The ribbon may be bent over a smaller radius of the circuit board containing no electronic components and such bends should be made once and fixed in position to avoid cyclic fatigue.
Safety Information:
1.The SMD light ribbon itself and all their components may not be mechanically stressed
2.Assembly must not be damaged or destroyed on some conductive bus of the circuit board
3.Installation o |
| Company: |
Light Electronic Ltd.
|
| Contact: |
Mr. Winger Joy |
| Address: |
Block 8, Asian Ind. Park, Gangtou, Buji Town, Shenzhen, China. |
| Postcode: |
518112 |
| Tel: |
86 755 81531101 |
| Fax: |
86 755 89512930 |
| E-mail: |
|
|
|
Home
